switching power

A Design and Simulation of Fuzzy Controller for a Switching Power Supply

开关稳压电源模糊控制器设计与仿真

Analysis on Switching Power for New No.9 Turnout with Curved Blades of Negative Secant Type

新型相离型曲线尖轨9号道岔的扳动力分析

This paper presents a miniaturized high-voltage DC-DC switching power supply for titanium getter pump, which is used for maintaining high vacuum environment.

介绍了一种应用于钛离子泵真空维持系统中的小型高压DC-DC开关电源。

The experiments of the nonlinear behaviors such as period-doubling bifurcation, tangential bifurcation, chaos and intermittent chaos in DC-DC switching converters have been done. In addition, the experiments of the interleaved boost converter in MPPT for PV power system are performed.

我们对DC-DC开关变换器电路中的倍周期分岔、切分岔、阵发混沌、混沌等非线性现象以及光伏发电MPPT中交错并联boost变换器进行了较全面的实验研究。

A device which has an extremely high input impedance, low switching speed and low power consumption.

一种高输入阻抗 、 低开关速度及低功耗的半导体器件.

In addition to design methods and schematic of the main cell circuit modules, this paper also put forward measures of reducing switching noise on monolithic switching power IC.

文中除了对芯片设计方法、思路及主要电路模块结构的设计方案进行讨论外，还提出了减小单片集成开关电源噪声的措施。

Reduction of Conducted EMI in switching power supplies using chaotic frequency modulation scheme ( CFMS) is proposed.

探讨了混沌频率调制技术在开关变换器中抑制电磁干扰的实际效果。

For example, switching power supply circuit that is an important indicator is the high power factor hard to reach this target, in the power circuit design is necessary to choose a variety of electronic switch components, to the power of transformation.

例如开关电源电路，该电路的一个重要硬性指标就是高功率因数，为了达到这一指标，在电源电路的设计中就要选择各种电子开关元器件，来进行电能的变换。

A Switching Power Supply with Multiple Outputs Used in Network Analyzer

网络仪用高效率多路电源设计

This paper describes the general design rules of switching power amplifier and analyses different control strategies.

本文讨论了开关功放设计的一般原则,分析比较了不同的控制策略.

Comprehensive Identification for Common Faults of Load Tap Switching of Power Transformer and Trouble-shooting on Site

变压器有载分接开关常见故障的综合判断与现场处理

Circuit, logical control circuit, switching power supply main circuit and its parameters calculate were discussed.

介绍了稳定可靠的调Q电路、逻辑控制电路和开关电源的主电路及其参数计算。

Study of Based on PWM Rectifier Switching Power Supply

基于PWM整流器的新型开关电源的研究

The switching power supply be the same with 26 " —37 " LCD TV module.

此电源适用于 26—32 英寸液晶电视机模组.

The device has a higher efficiency than the conventional switching power supply with PWM, and it is almost load-independent.

这类开关电源的效率比常规的脉冲宽度调制（PWM）高，且基本上与负载无关；

Research on Flame-proof& Intrinsically Safe DC Switching Power Supply

隔爆兼本安直流稳压开关电源的研究

This System consists of accelerograph control cell 、 speed control cell and switching power control cell.

本系统由柴油机油门控制单元、柴油机转速控制单元和功率切换控制单元组成。

Simulation of Constant Voltage Switching Power Supply with Feedback Loop

高频开关电源的闭环仿真研究

Low Ripple Design of the Switching Power Supply Used in Radar Receiver

用于雷达接收机的开关电源的低纹波设计

The report introduces a kind of new Magnetic Amplifier and its application in switching power supply.

本文通过介绍磁饱和放大器的原理以及PC电源和MA电源在各种负载下的比较试验来说明一种最新磁饱和放大器及其在开关电源中的应用情况。

A cyanide-free alkaline Cu plating process using a strike-to-intermittence two-stage automatic switching power supply was developed.

提出了一种采用冲击镀转间隙镀两级跳自动电源的无氰碱铜工艺.

Low-power switching power characteristic of Low Loss high rate of conversion small size and light weight.

针对体积小,可靠性高,待机功耗低的小功率开关电源.分析了国内外开关电源的发展和现状.

Research on Soft Switching Power Factor Correction Circuit with Power Electronics Integration Technology

采用电力电子集成技术的软开关PFC电路的研究

Measures for Automatic Switching Power Supply According to Upper-lower Limit of Temperate with Temperature Controller of XMT ── 121

用XMT&121温控仪实现温度越限自动通断电控制的措施

Purpose: Audio frequency low power amplifier, driver stage amplifier, switching applications.

用途: 用于音频小功率放大, 激励级放大及开关电路.

Purpose: Audio frequency power amplifier and low speed switching applications.

用途: 用于音频功率放大和低速开关.

Tape out device and test. Extraction of device parameters and the establishment of device models the models use for switching power supply circuit design and simulation.

器件流片、测试后，提取器件参数以及建立器件模型，然后进行开关电源电路设计和仿真。

Using single terminal inverse excitation type converter priciple, eight independent output switching power supply is developed.

采用单端反激电流型变换器的原理，研制成多达8路独立输出的开关电源。

The switching power supplied insolated DC power to IPM, DSP control circuits, sensor and cooling fans.

开关电源输出隔离的电源分别给IPM的驱动电路、DSP控制电路、传感器以及冷却风扇供电。

Based on the soft-switching power supply and by applying the CAN bus technique, a synergic controlled Tandem twin-wire high-speed welding equipment was developed.

在软开关电源的基础上，利用CAN总线技术研制了协同控制的Tandem型双丝焊装备。